BobertmaX

A sample of some of the parts available in the full kit.

Pre-supported and test printed, Micro Gundam Model kit.

More info here : 

or

Or on bootsy https://boosty.to/bobertmax

A sample of some of the parts available in the full builder.

Pre-supported and test printed, 6mm Battlemech.

More info here :

or

Or on bootsy https://boosty.to/bobertmax

Another fantastic model by BLaaR (which was based on his own paper
model plans), with his permission, I remixed a few parts, added some
detail here - and there, slapped some MWO styled lasers in there and
scaled it to be (~roughly~) in line with some other patreon resin
Battlemechs (Like the MW4 Fafnir). Also, besides the standard
MechWarrior 4 version, I have included a more 'classic' inspired
Templar, with a loadout in line with TLR1-O. Each version has two poses,
which can be mirrored for even more options.

Based on the fantastic model by BLaaR (which was based on his own paper model plans), I remixed a few parts, added some detail here - and there, slapped some MWO styled lasers in there and scaled it to be (~roughly~) inline with some other patreon resin Battlemechs.

MechWarrior Online Mad Cat MKII, roughly 140mm tall.

Fully articulated, and tested, all parts should be 100% printer friendly and
error free. With multiple Torso and weapon options (more than any
previous), and like the Atlas, does not require any glue for assembly.
LRM pods can be printed separately and attached to certain torso's to
make even more options than the 12 that I provided, and I added a few
more weapon attachments as well as re-doing a few. Making this the most
customizable 'Mech That I have done to this point.

MechWarrior Online Timberwolf, roughly 130mm tall.

Fully articulated, and tested, all parts should be 100% printer friendly and
error free. Most of the joints are the same as the Articulated MWO
Timberwolf by 7Fish (https://www.thingiverse.com/thing:2739971),
aside from the ones that I edited (I added ball joints to the upper
legs and in the arms, and I edited the ankle joint to allow for ankle
tilt).

**If you would like to print one of my optional torso or
weapon parts but want to print the rest of the Timberwolf by 7Fish (if
you would like to use his prebuilt supports for eg.) you can do so, and
everything should fit/work.

MechWarrior Online Hellbringer, roughly 130mm tall.

Fully articulated, and tested, all parts are error free and printer friendly.
Multiple Torso and weapon options, and like the Atlas, does not require
any glue for assembly. I used a scale table from Mech Warrior Online to
scale the 'Mech. But if you would like to print it a little bit smaller,
most of the detail and joints should still print/work at 75% ~though I
have not tested this.

MechWarrior Online Huntsman, roughly 125mm tall.

Fully articulated, and tested, all parts should be error free and printer
friendly. Multiple Torso and weapon options, and like the Atlas, does
not require any glue for assembly. The scale might not be quite right
though, as I scaled it so that the medium lasers were roughly the same
size as the ones on the Atlas. And I also used a scale table from Mech
Warrior Online, but, as the Huntsman was not on the table I had to guess
a little using other 'Mechs in the same weight class. I have printed it
at 75% scale and most of the detail, and all the joints still
print/work, so if you would like it slightly smaller it should be fine.